Fedora Linux Client Configuration Guide

Download Gateway6 5.1

1. Visit http://go6.net/4105/download.asp, and download "Gateway6 5.1 Source Code (Linux/Unix/Darwin/BSD)".
2. Extract the file.

Installation Guide

1. When the file is downloaded extract the file using the command. tar -zxvf gw6c-5_1-RELEASE-src.tar.gz
2. When the extracting has been completed, navigate into the tspc-advanced folder. To do this type the command cd tspc-advanced this will then take you into the folder. Once in the folder type the command make all target=linux. This will then compile the program ready for installation.
3. Now it's time to install the application. Type the command make install target=linux installdir=/usr/local/gw6c in this will install the application.
4. Move to the folder that the application was installed. In this case it was cd /usr/local/gw6c/bin
5. Type the command chmod +x /usr/local/g26c/template/*.sh. This command will alter the permission of any file name with a .sh extension.
6. Now we need to edit the configuration file. To access the file type vi gw6c.conf. This will then open up the configuration file for the application.
7. We now need to change the configuration details. To enter the configuration simply refer to the screenshot below.
   
   Below is an example of a completed configuration file. Just replace the bold text with your Internode username and password details. The "if_prefix" is the name of your ethernet driver.

   userid=yourinternodeusername
   passwd=yourinternodepassword
   server=sixgw.internode.on.net
   auth_method=any
   host_type=router
   prefixlen=64
   if_prefix=yournormalinterface
   dns_server=192.231.203.132
   gw6_dir=/usr/local/gw6c
   auto_retry_connect=yes
   retry_delay=30
   keepalive=yes
   keepalive_interval=30
   tunnel_mode=v6anyv4
   if_tunnel_v6v4=gif0
   if_tunnel_v6udpv4=tun0
   if_tunnel_v4v6=
   client_v4=auto
   client_v6=auto
   template=linux
   proxy_client=no
   broker_list=tsp-broker-list.txt
   last_server=tsp-last-server.txt
   always_use_same_server=no
   log_filename=gw6c.log
   log_rotation=yes
   log_rotation_size=32
   log_rotation_delete=no
   syslog_facility=USER
   

8. Now radvd needs to be installed. This can be downloaded by using the "yum" command. (yum install radvd)
9. This will then ask you to confirm if you want this information installed onto the computer. Press the "Y" key and then hit "enter"
10. When the installation has been completed, there will be a 'Completed' message.
11. Type the command ./gw6c this will then start the IPv6 tunnel
12. To make sure that the tunnel is working type ifconfig to view the IPv6 address.
13. To confirm that the service is working correctly use the command ping6 to ping over IPv6. Or you can go to http://www.kame.net to also find out if the service is running correctly.